Once scan has been completed, and all the metadata
captured for an OSD has been persisted to
the OSD is now ready to get “activated”.
This activation process disables all
ceph-disk systemd units by masking
them, to prevent the UDEV/ceph-disk interaction that will attempt to start them
up at boot time.
The disabling of
ceph-disk units is done only when calling
simple activate directly, but is avoided when being called by systemd when
the system is booting up.
ceph-volume simple activate 0 6cc43680-4f6e-4feb-92ff-9c7ba204120e
The above command will assume that a JSON configuration will be found in:
Alternatively, using a path to a JSON file directly is also possible:
ceph-volume simple activate --file /etc/ceph/osd/0-6cc43680-4f6e-4feb-92ff-9c7ba204120e.json
The OSD uuid is being required as an extra step to ensure that the right OSD is being activated. It is entirely possible that a previous OSD with the same id exists and would end up activating the incorrect one.
With OSDs previously scanned by
ceph-volume, a discovery process is
lvm. There is currently support only for
devices with GPT partitions and LVM logical volumes.
The GPT partitions will have a
PARTUUID that can be queried by calling out
blkid, and the logical volumes will have a
lv_uuid that can be
lvs (the LVM tool to list logical volumes).
This discovery process ensures that devices can be correctly detected even if
they are repurposed into another system or if their name changes (as in the
case of non-persisting names like
The JSON configuration file used to map what devices go to what OSD will then coordinate the mounting and symlinking as part of activation.
To ensure that the symlinks are always correct, if they exist in the OSD directory, the symlinks will be re-done.
systemctl enable ceph-volume@simple-$id-$uuid
systemctl enable ceph-volume@simple-0-8715BEB4-15C5-49DE-BA6F-401086EC7B41
Would start the discovery process for the OSD with an id of
0 and a UUID of
The systemd process will call out to activate passing the information needed to identify the OSD and its devices, and it will proceed to:
- # mount the device in the corresponding location (by convention this is
/var/lib/ceph/osd/<cluster name>-<osd id>/)
# ensure that all required devices are ready for that OSD and properly linked. The symbolic link will always be re-done to ensure that the correct device is linked.
# start the
ceph-osd@0 systemd unit